Broken printing plates made whole
Gluing metal? You would imagine that a broken metal object would need to be welded back together. Not necessarily. These damaged printing plates were made whole using glue—though not the stuff you used in grade three.
A treasure trove of artifacts
Having recently blogged on the conservation of a 19th century printing press, it seemed appropriate to write a blog on the conservation of printing plates that may very well have been used on this press. In May 2013, the Museum acquired for its National Currency Collection more than 650 engraved steel dies (printing plates) from the British American Bank Note Company. (Read more about this acquisition.)
But, we couldn’t place the dies in storage straight away. There were assessments to be made, labels to be detached and a little clean-up was called for. Each die was wiped down with mineral spirits and soft cotton swabs to remove a dark, greasy substance that covered the surfaces—evidence of their past use as security printing plates. During this cleaning process, we discovered that eight dies were broken in half, likely from past printing activity. After further evaluation, we decided to repair the breaks.
Conserving the plates
Artifact preservation is the non-invasive act of minimizing and preventing future damage or deterioration. Artifact conservation has the same goal but with the addition of hands-on treatments such as cleaning and repairing.
In heritage conservation, broken metal objects can be reassembled with an adhesive most commonly used for repairing glass and ceramics. This adhesive, known as HXTAL, is a two-part epoxy resin which, through a chemical reaction, hardens after mixing. It works well with dense materials as it creates strong, tight bonds and has the added benefit of neither swelling nor discolouring over time.
Each die was reassembled, held together with thin strips of painter’s tape and then placed upright in clamps. Small drops of HXTAL were then applied along the break with the tip of a wooden stick. Capillary action then draws the glue into the break. The next day, any remaining adhesive was removed with swabs and wooden sticks lightly dampened with acetone. This is important because after 24 hours, HXTAL will become too hard to be removed without the potential of damaging the object. The dies were then left in the clamps for an additional week until the adhesive had fully cured. The final step was to create custom mounts for each die to ensure they are properly supported while in collection storage.
It is both our pleasure and our duty to preserve items such as these dies for the future. They are a glimpse into our economic and social history as well as into printing traditions that reach back nearly 600 years.
How’re We Doing So Far?
By: Graham Iddon
It’s all good, and we couldn’t be happier with our first few weeks of business.
Unpacking the Collection 6
By: David Bergeron
In 1934 the Department of Finance invited Emanuel Hahn to submit a design for a silver dollar to commemorate the Silver Jubilee of King George V’s reign.
Our Grand Opening…
By: Graham Iddon
After four years of plans, worries, setbacks, successes and sheer hard work, the Bank of Canada Museum opened its doors—on Canada Day, right on schedule.
Museum Reconstruction - Part 8
By: Graham Iddon
The last few stragglers among our artifacts are ready for installation and the interactives and digital labels are bulking up with the final software and data, in them, so it’s all there, functional and looking fantastic.
The Yap Stone Returns
By: Graham Iddon
For us, its removal from the Garden Court dramatically marked the Currency Museum’s closing. The big stone’s return now performs the opposite role for the new Bank of Canada Museum—heralding its opening.
A New Ten on the Block
By: Graham Iddon
In a modern twist, Governor Stephen S. Poloz took a “selfie” while holding a C150 note before meeting up with the Honourable Ginette Petipas Taylor for the main photo op.